编程单个SB8F
在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，夹爪厂家，直到READING红灯开始闪烁，电动夹爪，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。
Before programming the sensor box，夹爪， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for 3 seconds until the READING red light starts fashing，气动夹爪， then release it.The red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).
传感器
磁性传感器(可选) 通过活塞上的一个磁铁检测出操作位置。因此，大量的磁性材料和强烈的磁场可能会造成传感问题。
The operating position is detected by proximity magnetic sensors
(optional) through a magnet p1aced on the piston.
Therefore， avoid using the gripper in the vicinity of intense
magnetic ffelds or near a large mass of ferromagnetic material
as this may cause detection errors.
双钳口自动对准平行i气动钳夹 (SX系列)
?双动作 (可按需关闭)。
?高夹紧力。
?防护等级为IP67。
?列柱向上采用双层O型圈设计。
?适用于恶劣的环境。
?可选的磁传感器。
?FDA-H1 食品级润滑脂
?Double acting (normally closed on request).
?High gripping force.
?Protection class: IP67.
?Double O-Ring sealing on the columns.
?Suitable for harsh environments.
?Optional magnetic sensors.
?FDA-H1 food-grade grease.
气动夹爪-夹爪-吉玛泰克由吉玛泰克自动化工程（常熟）有限公司提供。吉玛泰克自动化工程（常熟）有限公司为客户提供“机械手前端治具，真空系列，传感器，机电一体化组件”等业务，公司拥有“吉玛泰克自动化工程”等品牌，专注于气动工具等行业。，在江苏省常熟市古里镇通华路1号2幢的名声不错。欢迎来电垂询，联系人：吴琦。